I was finally able to upgrade the firmware on my old but trusty D-Link DIR-868L router to Tomato firmware.
The process is a little bit involved and it’s very easy to brick your router. Fortunately, this router provides a relatively easy way to perform recovery.
Note this instruction is for DIR-868L rev A1. There are more than one version of this router and the process could differ for each of those versions.
At a high level, you will need to upgrade the firmware to DD-WRT first and then to Tomato. We will use Tomato by Shibby.
Step 1: Upgrade to DD-WRT
You cannot simply use any DIR-868L version of DD-WRT firmware. You need R25974 or prior. If you use any firmware after that version you may not be able to flash it and if that happens your device will be bricked.
You will need two files: factory-to-ddwrt.bin and dir868-webflash.bin
Download the two files from this link. The links are for R25974.
After you download, first flash the firmware “factory-to-ddwrt.bin” using the D-Link router’s firmware upgrade page.
The process could take up to 3 minutes. Once successfully flashed your router will reboot. Then go to the router page (default is 192.168.1.1) and immediately upgrade the firmware to “dir868-webflash.bin“. If all goes well router will reboot once again. At this point, you are set to proceed to Step 2
Step 2: Upgrade to Tomato firmware
Download the latest Tomato by Shibby firmware from this link. The build I used was 140; direct link.
Download the zip file and extract it. Then flash the “tomato-DIR868L-ARM–xxx-special.trx” file with “Reset to Default Settings”. As usual the process could take up to 3 minutes. Once complete, Tomato firmware should boot up. Right after this, go to “Administration -> Configuration” and choose “Erase all data in NVRAM memory (thorough)” option. This will take a few more minutes. Once done, you are all set!
Bricked the router?
D-Link DIR-868L provides an easy way to recover.
- Download the latest available firmware on the official D-Link website of the router revision
- Unplug all cables (incl. power cable) from the router
- Connect the router to the PC using one of the 4 switch ports
- Set the PC TCP/IPv4 address to 192.168.0.2 and use 255.255.255.0 as the Subnet mask
- Power-on the router with a paperclip pushing the hidden reset button located on the bottom of the device for a few seconds, when the Power LED starts blinking, release the reset button
- Open browser and navigate to http://192.168.0.1
- Upload the stock firmware, when completed the router should report to reboot
- The router should now be running stock and accessible on the default address.
3 thoughts on “Upgrading D-Link DIR-868L A1 firmware to Tomato”
must use firefox browser to flash the firmware. other browser might not work.
Rev. A FW 1.21 (Krøøk exploit) : uploaded factory-to-ddwrt.bin Build 40559, 36247, 27096 and at last 25975 : the router seems to reboot but nothing changes (customized ip adress still alive) and impossible to upload dir868-webflash.bin : request too enlarge)…
Thanks, only way I have managed to get Tomato on this router